This file can be used in the following paths:
- • c:\intergraph\erdas imagine 2013\bin\win32release\
- • c:\program files (x86)\arcgis\desktop10.5\bin\
- • c:\program files (x86)\arcgis\desktop10.4\bin\
- • c:\arquivos de programas\multispectral\geoportal 3d 0.9\
- • c:\program files\hexagon\erdas imagine 2015\bin\win32release\
- • c:\installer\2014 erdas\imagine-v14.0-win-x64\repository\imagine x64\setup\program files 64\intergraph\erdas imagine 2014\bin\win32release\
- • c:\installer\2014 erdas\imagine-v14.0-win-x64\repository\imagine x64\setup\program files 64\intergraph\erdas imagine 2014\bin\x64urelease\
- • c:\program files (x86)\arcgis\desktop10.1\bin\
- • c:\mysoft\multism\circuit design suite 13.0\
- • c:\program files (x86)\multisim14.0\circuit design suite 14.0\
- • c:\eswin\bin\
- • c:\program files\leica geosystems\leica geo office\combined\bin\
- • c:\program files\glodon\gaq\3.0\bin\
- • c:\program files\glodon\gaq\3.0\bin\ggdbupgrade\
- • c:\cadence\spb_16.6\tools\3dviewer\
- • c:\nessy_000\desktop\wilcom embroidery studio e2 + crack + instructions\crack wilcom e2\64bits\patch\
- • c:\allycad33\
- • c:\program files\hexagon\erdas imagine 2015\bin\x64urelease\
- • c:\program files\leica geosystems\xpro sgm\
- • c:\program files (x86)\national instruments\circuit design suite 12.0\
- • c:\program files (x86)\national instruments\circuit design suite 14.2\
- • c:\$recycle.bin\s-1-5-21-1926019129-1322145355-2335414895-1001\$rzbiw6z\archicad 20\
- • c:\$recycle.bin\s-1-5-21-1926019129-1322145355-2335414895-1001\$rzbiw6z\archicad 20\previouslp_xmlconverter\
The above paths are the common paths where this file is located, but does not mean that it must be stored in the above paths. The file should be stored in the actual installation path of the software.
Tip: If you cannot find the software installation path, you can follow the path suggested above, find one by one, and put the file inside the path found.