This file can be used in the following paths:
- • c:\program files (x86)\siemens\automation\wincc rt advanced\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\11.0\cp_15_19_22\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\11.0\cp_4\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\11.0\cp_7_9\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\11.0\mp377\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\12.0\cp_15_19_22\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\12.0\cp_4\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\12.0\cp_7_9\
- • c:\program files\siemens\automation\portal v14\data\hmi\transfer\12.0\mp377\
- • c:\program files (x86)\common files\siemens\wincc flexible 2004 ocx\
- • c:\program files (x86)\siemens\simatic wincc flexible\wincc flexible 2008\transfer\1.4\mp377\
The above paths are the common paths where this file is located, but does not mean that it must be stored in the above paths. The file should be stored in the actual installation path of the software.
Tip: If you cannot find the software installation path, you can follow the path suggested above, find one by one, and put the file inside the path found.