This file can be used in the following paths:
- • c:\national instruments downloads\labview 64-bit\2014\bin\
- • c:\national instruments downloads\labview 8.5\runtime engine (full)\bin\
- • c:\bin\
- • c:\national instruments downloads\labview 64-bit\2016\bin\
- • c:\national instruments downloads\labview control design and simulation module\2011\bin\
- • c:\national instruments downloads\labview\2015\bin\
- • c:\national instruments downloads\labview 64-bit\2017\bin\
- • c:\national instruments downloads\labview\2016\bin\
- • c:\national instruments downloads\labview fpga english\2017\bin\
- • c:\national instruments downloads\labview fpga english\2016\bin\
- • c:\national instruments downloads\vision builder ai\2014\bin\
- • c:\national instruments downloads\labview\run-time engine\2015 (64-bit) f3 patch\standard\bin\
- • c:\national instruments downloads\vision development module\2014 sp1\bin\
- • c:\national instruments downloads\labview\statechart module\2015\bin\
- • c:\national instruments downloads\labview dsc\2015\bin\
- • c:\national instruments downloads\vision builder ai\2014 sp1\bin\
- • c:\national instruments downloads\vision development module\2012\bin\
- • c:\national instruments downloads\vision development module\2015\bin\
- • c:\national instruments downloads\labview\2013\bin\
- • c:\national instruments downloads\labview\2015 sp1\bin\
- • c:\national instruments downloads\labview\8.6.1\bin\
- • c:\national instruments downloads\ni circuit design suite education\14.1\bin\
- • c:\national instruments downloads\labview 64-bit\2018\bin\
- • c:\national instruments downloads\ni modbus\1.1\bin\
The above paths are the common paths where this file is located, but does not mean that it must be stored in the above paths. The file should be stored in the actual installation path of the software.
Tip: If you cannot find the software installation path, you can follow the path suggested above, find one by one, and put the file inside the path found.